Mint NextMove PCI Manuel d'utilisateur télécharger pdf (Page 28)

Accessories for NextMove PC

BreakOut Module & Cable

The breakout module provides a fast and reliable

method of connecting signals to the NextMove PC.

All I/O wiring is connected using screw connectors.

Encoders use 9 pin D type connectors with the same

pinout as other MINT™ motion controllers. Two

CANbus connectors allow easy daisy-chaining of the

CANbus network.

The breakout module is DIN rail mount and can be

connected to NextMove PC using a Baldor cable

assembly. The entire assembly, NextMove PC, cable

and breakout module, has been designed to ensure

continuous shielding of all signals and to meet CE

requirements.

CANbus Accessories

NextMove PC features one CANbus port for

connecting to Baldor’s I/O modules and operator

panel. These accessories offer connection simplicity

and a fast and reliable method of expanding the

capabilities of the NextMove PC.

Canbus is a high integrity, two wire serial link that

transfers data at rates up to 1M bit/second over a

distance of 130ft/40m. (3200ft/1000m at

50Kbit/second). With just twisted pair, machine wiring

costs material and installation - can be greatly reduced.

At the same time, the reduced number of wires can

provide greater machine reliability

NextMove PC supports the following CANbus

accessories.

8 digital input modules

8 digital output modules

8 relay output modules

24 input, 24 output modules

Operator Panels (maximum of 4)

A maximum of 63 CANbus accessories may be

connected to NextMove PC.

Each CANbus accessory has two CANbus connectors

which are electrically identical. This allows several

modules to be ‘daisy chained’ using Baldor’s point to

point cable assemblies. I/O modules can be DIN rail

mounted for easy installation.

8 Input Module

• 8 digital inputs.

• Opto isolated and may be connected to positive or

negative common (for use

with NPN and PNP output

transistors).

• Inputs are guaranteed to

be active in the range ±

12V to ± 24V and inactive

between ±2V

• LEDs indicate status of

each input.

• Read from MINT program

using REMOTEIN

keyword.

• Two part connectors for power

and inputs.

• Power requirements: +12 to +24VDC, 45mA to

90mA respectively.

8 PNP Output Module

• 8 digital outputs.

• Opto isolated and

protected against over

current and over

temperature.

• 50mA continuous source

on all channels.

• 350mA max source on

single channel.

• 500mA max total output

for all 8 channels on simultaneously.

• LEDs indicate status of each output.

• Written from MINT program using REMOTEOUT

keyword.

• Two part connectors for power and outputs.

• Power requirements: +12 to +24VDC, 110mA to

130mA respectively.

8 Relay Output Module

• 8 relay outputs.

• Form C (SPDT)

relays rated at

24V (1A).

125 VAC (0.5A),

30 VDC (2A).

• LEDs indicate

status of each

output.

• Activated from MINT

program

using REMOTEOUT keyword.

• Two part connectors for power and outputs.

• Power requirements: +24VDC (215mA).

ION001-501

3.87/86mm

ION003-501

3.8/86mm

ION002-501

NMP004-501

4.9/125mm

11.50/292mm

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Mint NextMove PCI Manuel d'utilisateur Page 28

Commentaires sur ces manuels